Dlink Hacking

How To Upgrade Firmware. (coba-coba menulis inggris nih.. :D)

Note: Upgrading firmware will reset the settings to default which means you will lose all your settings. Also, do NOT upgrade firmware over a wireless connection. You may damage the unit.

Step 1
Download the firmware and save the file to your computer.
Extract the .BIN or .TFP file to a folder where you can find it.
An easy place to find it is your desktop. If you download the .bin or .tfp file,
you do not have to extract it.

Download firmware at http://www.dlink.com.au/tech/.

Step 2
If you are connecting the unit directly to your pc you may need a cross-over cable.
Connecting to a switch or router you will use a straight through cable.
Link light on the LAN port indicates that you are using the correct type of cable.

WARNING: DO NOT upgrade the firmware with a wireless connection. You will damage the unit.

Step 3
Open your browser, enter the IP address of your access point (192.168.0.50) and click OK.

Step 4
Enter your username (admin) and leave the password field blank, which is the default password.
Click OK to enter the web configuration for the device.

Step 5
Click on the Tools tab and then the Firmware button on the left side.
Click on the Browse button and browse to the .bin or .tfp file you extracted in Step 1.
Highlight the file by clicking on it once and click Open. Click Apply.
It will take a few seconds for the upgrade to complete. Click on the Continue button.

Step 6
After the access point reboots, close your web browser and reopen it.
Enter 192.168.0.50 to reconnect with the web configuration.
Enter username admin and again leave the password blank. Click OK.
The firmware upgrade is now complete.

Step 7
If you have problems with the web configuration at this point, unplug the power to the access point, wait 10 seconds, and plug back in.
Repeat step 6. If this did not help, perform a hard reset on the access point. To perform a hard reset, use a paperclip and hold down the reset button on the back of the unit for 10 seconds while the device is powered on.
Release it and the access point will reboot, the lights will blink, and then stabilize.
Repeat Step 6.

Step 8
You can now reconfigure the access point.

Step 9
Open your command, enter the IP address of your access point (192.168.0.50) and click OK.

Step 10
Enter your username (admin) and leave the password field blank, which is the default password.

Step 11
input "set regulatorydomain none" enter

Step
12 input "set overridetxpower xx" enter

step 13
input "set channel" enter

So try this at home.. Enjoyed Dlink hacking.
(Selamat mencoba...) :D